Hi
Kenneth Roy Cabrera Torres wrote:
> Hi Dear SL users:
>
> I use to have SL3.05 (CERN version), then I upgrade to 4.0 (GENERIC)
> every thing was OK, except the printer I got the following message
> when I try to send a test page to the printer:
SLC305 (SL CERN version) uses CERN-specific printing
mechanism: while upgrading to stock SL this is not taken
into account.
Proceed as follows:
#rpm -e xprint xprint-cups cern-config-printer
#yum upgrade
Best Regards
Jarek
__
-------------------------------------------------------
_ Jaroslaw_Polok ___________________ CERN - IT/ADC/LE _
_ http://home.cern.ch/~jpolok ___ tel_+41_22_767_1834 _
_____________________________________ +41_78_792_0795 _