Hi

Kenneth Roy Cabrera Torres wrote:
> Hi Dear SL users:
> 
> I use to have SL3.05 (CERN version), then I upgrade to 4.0 (GENERIC)
> every thing was OK, except the printer I got the following message
> when I try to send a test page to the printer:

SLC305 (SL CERN version) uses CERN-specific printing
mechanism: while upgrading to stock SL this is not taken
into account.

Proceed as follows:

#rpm -e xprint xprint-cups cern-config-printer

#yum upgrade

Best Regards

Jarek

__
-------------------------------------------------------
_ Jaroslaw_Polok ___________________ CERN - IT/ADC/LE _
_ http://home.cern.ch/~jpolok ___ tel_+41_22_767_1834 _
_____________________________________ +41_78_792_0795 _