William Shu wrote:
> Hi,
> I have 3 issues related with using my wireless router, and
> making sure changes take effect at boot time.
>
> ISSUE 1: Obtaining DHCP from router
> My wireless router can be used if my machine (an hp pavillion
> 5000 series laptop) is given a fixed IP address. For this to
> happen, the ipW3945d service (driver) has to be activated so
> that the wireless connection is associated with the eth1
> interface. (From the HOWTO's this is done so that sofware that
> can change certain wireless connectivity parameters into
> unlawful values cannot be tampered with by a user, which is an
> FCC legal requirement) eth0 is associated with the wired network
> interface.
>
> My router may issue DHCP IP addresses, but I cannot use the
> wireless connection because I would need the issued IP address
> to configure the eth1 interface needed for the connection!
> Unfortunately, the router cannot issue both fixed and DHCP IP
> addresses at the same time! Furthermore, the accepted address
> range set for the router need not be known by the user, who need
> not have root/admin access.
>
> QUESTION: How can I configure my eth1 interface so that it can
> get a DHCP IP address from the router?
What brand/model of wireless router? I failed to get a dlink working,
though I've had n problems with Apple's airports or a linksys.
I don't use the builtin dhcp server, but I do use dhcp.
>
>
> ISSUE 2: Adding configuration start-up commands at boot time
> The following are actually more of linux boot-related questions:
> I used /sbin/chkconfig to start the ipw3945d service at boot
> time. However, the initialisation commands
> # /sbin/iwconfig eth1 essid "doit1wlan" channel 6 rate auto
> txpower auto
I would not specify the channel on a client.
> # /sbin/iwconfig eth1 key open s:xxxxx
what's that work "open?" "key" is supposed to be followed immediately
by the key.
> # /sbin/ifconfig eth1 up 192.168.110
> which are used to configure the device are lost.
>
> QUESTION: How should I save these commands so that they are
> automatically executed at time? (.bashrc does not seem right!)
If you use RH's configuration tools, it should all work. The
information's stored in /etc/sysconfig/network-scripts and it's possible
to edit the files with a little vim, but I prefer to see something to
work on.
>
>
> ISSUE 3: Controlling Services across sessions
> Sometimes, when my laptop runs out of power and shuts down, the
> subsequent reboot restart or resume some of the programs
> (processes) that were running before. This does not happen when
> I shutdown the system. I have deleted the processes from the
> current session services, but they still re-appear on subsequent
> boots. (such processes seem to be hvve unusual names, id's or
> directory paths appended/prepended to them). I think at one time
> in the distant past, pm-hibernate or pm-suspend had been called.
>
If the system hibernates, then it should resume to the same state it was
in before. By definition.
> QUESTION 1: How can I turn this on or off -- at my discretion?
I have in the past had success setting my choices in KDE>
--
Cheers
John
-- spambait
[log in to unmask] [log in to unmask]
-- Advice
http://webfoot.com/advice/email.top.php
http://www.catb.org/~esr/faqs/smart-questions.html
http://support.microsoft.com/kb/555375
You cannot reply off-list:-)
|