yes, all disks were created with image burn.
disk1 works fine, but not disk2 (haven't tested disk3 as yet).
vivek
-----Original Message-----
From: Connie Sieh
To: Jain, Vivek
Cc: [log in to unmask] ' '
Sent: 6/7/2005 11:45 AM
Subject: RE: problems with second disk of SL3.0.3
The 500mb should all be on disc 1.
On Tue, 7 Jun 2005, Jain, Vivek wrote:
> HI Connie,
>
> We tried to do a installer media check on disk 2 and we get an
>
> "Error
>
> Unable to read the disc checksum form the primary volume descriptor.
This
> probably means the disc was created without adding the checksum."
>
>
> As far as I know, we didn't do anything different when burning disk1
or
> disk2. We burned the disks on a Windows XP machine using NERO (burn
rate was
> set at 8X - minimum).
I assume this was a "image" burn.
-connie
>
> Also, we managed to boot up the system just using disk1 alone.
Bare-bones -
> no X11, no nothing. Not clear to me how to access stuff over the
network.
>
> Any advice will be appreciated.
>
> vivek
>
>
>
> -----Original Message-----
> From: Jain, Vivek
> To: 'Connie Sieh '
> Cc: [log in to unmask] '
> Sent: 6/7/2005 11:22 AM
> Subject: RE: problems with second disk of SL3.0.3
>
> Hi COnnie,
>
> We only checked disk1 with the "installer" media check. We can try
> disk2 also.
>
> At the moment, we chose custom but didn't check-off any packages;
claims
> the size of the install will be approx. 500 MB; hopefully it is all on
> disk1.
>
> thanks
> vivek
>
> -----Original Message-----
> From: Connie Sieh
> To: Jain, Vivek
> Cc: [log in to unmask]
> Sent: 6/7/2005 11:18 AM
> Subject: Re: problems with second disk of SL3.0.3
>
> On Tue, 7 Jun 2005, Jain, Vivek wrote:
>
> > Hi all,
> >
> > We are trying to install SL3.0.3 on a machine. We are using the
Custom
> > install setting. After the first CD was read, it asked for the
second
> one.
> > For some reason, it keeps complaining that we are not putting in the
> correct
> > CD. We have used CD's burned on two different machines. We checked
the
> > md5sum for the downloaded image - it looks fine. We are checking the
> md5sum
> > of the image as burned on the disk (it's taking some time).
> >
>
> Are you checking the cd with the "installer" media check?
>
> > Our CD drive is OK - we just checked it by reading disk1 again.
> >
> > In any case, is it possible to setup a configuration where we only
use
> disk
> > 1 for now. We can add in the other packages later (via network, for
> > instance).
>
> Only select the bare minimum with custom.
>
> >
> > vivek
> >
>
> -connie sieh
>
|